![]() ![]() ![]() Its rated for 30-40AMP but I have replaced the fuse with 10 given I have the single light bar. Is there somewhere else I should store all of this? I am also concerned with this cheap wiring harness being that the power is 14g and many of the other wires are 18 and 20g. My idea currently is maybe to store all of it in an electrical housing and secure in the front storage compartment and run the wires through the drain plug, use one of the bolts inside for the ground. I don't feel like there is a whole lot of space to just zip tie this stuff to the frame and I don't know how weather-proof this would be. My issue is really how to run all of the wiring including the relay, a couple of fuses, etc. I have cut a hole in the blank rubber service switch in the housing and this worked-out fitting nicely and providing good weather-proofing for the switch. I am not using the blue rocker switch and instead went for this waterproof switch:ġ2V Red Lighted Rocker Switch Water Resistant 3 Terminal LED Light Bar Rigid | eBay ![]() Wiring Harness Blue LED Light Bar Laser Rocker Switch on Off Relay Fuse ATV Jeep | eBayġ2inch 72W CREE LED Work Light Bar Spot Flood Combo Offroad Pickup Van ATV 12V | eBay Key here is its CHEAP! But I need help installing as I don't know the best way based on how ATVs are used out in the open. Hey guys I know there have been a few discussions on this but wanted to offer my setup. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |